How to carry out daily maintenance on laser marking machine?

          When we usually use laser equipment, whether it is our laser welding machine, our laser drilling machine or our laser marking machine, the laser is the central part of the machine. Our protection of the laser must be in place to make the service life of our laser equipment longer. Every time there is a problem, we can deal with it in a correct way, and the frequency and service life of our laser equipment can be greatly improved. When we use laser equipment, the laser has requirements for the operating environment. For example, for laser welding machines, it is more appropriate to open the laser at this time than when the temperature of the water-cooled machine reaches 25 degrees. In the process of equipment use Try to be in a dust-free environment. If dust falls into the lens, beam expander, mirror and laser equipment in a dusty environment, the dust will enter the machine’s service life. If you have to use it in this environment, it must be It is necessary to protect and organize on time to avoid affecting the normal operation of the equipment. Robot laser welding machine

When we use laser equipment daily, if the laser is not connected to the power, do not rush to switch the laser back and forth. You should check whether the adapter is energized, whether the equipment is grounded, and whether the wire is damaged. All conditions must be checked. If you exceed your own talent scale, you must get in touch with us, and we will send professional skills for counseling or on-site treatment. If the temperature is too high, it must be the laser temperature is too high. The correct way to deal with it is to check whether the flow rate of the water chiller is too low, resulting in poor cooling effect, turn off the equipment when necessary, and wait for professional engineers to deal with it. Jewelry laser spot welding machine

      If the laser beam is weak, the troubleshooting method is more difficult. We need to check whether the working parameter frequency has changed. If it is too low, pay attention to it, it may damage the crystal. If the problem has not been resolved, check whether the power parameter has changed or changed. The UV laser marking machine needs to increase the power parameters, generally adjusting the pulse width and current. If the above processing has not been processed, it is recommended to check whether the lenses are covered by dust. The dust should be sorted in time and checked regularly according to the factory environment. Organize and protect. If the above methods cannot handle the weak laser beam, professional personnel are required to deal with it.